GILLIG LOW FLOOR, Руководство по обслуживанию

Страница: 51 / 506

Preventive Maintenance
5
Electrical (Continued)
Fire Suppression Systems
Inspect system for bottle pressure and system OK ........................................Daily
Pre-operational check described in the manufacturer’s manual ....................Daily
Check/test system per manufacturer’s recommendations
*
............................. Every 30 days
* It is crucial that you refer to the manufacturer’s manual, included with the coach, for monthly, semiannual,
and yearly testing/maintenance information!
Batteries
Check cables
*
, hold downs, and boots ........................................................... Every 6,000 miles
Check open circuit voltage with DMM & service any that are low (<12.4 VDC) & check system
........................................................................................................................ Every 6,000 miles
Clean batteries of dirt and acid ...................................................................... Every 6,000 miles
Inspect for bulging case, damaged terminals ................................................. Every 6,000 miles
Check battery electrolyte level and connection torques
*
............................... Every 12,000 miles
Test with Midtronic tester per manufacturer’s procedures. ........................... Every 12,000 miles
Check voltage regulator settings ................................................................... Every 24,000 miles
* See torque values in the “Power Cables” schematic in the Electrical Schematics Manual .
Starter
Inspect cables for damage or corrosion ......................................................... Every 6,000 miles
Remove cables, reapply Kopr-Shield, and re-torque cables
*
........................ Every 36,000 miles
Inspect bolts, cable support clamp, and brushes ........................................... Every 36,000 miles
Check starter engagement protection circuit ................................................. Every 36,000 miles
Check pinion teeth for damage ..................................................................... Every 120,000 miles
†
Service starting motor .................................................................................... Every 120,000 miles
†
* See torque values in the “Power Cables” schematic in the Electrical Schematics Manual .
† Every 120,000 miles or every 30,000 starts. If you detect any chips or damage on the ring gear,
replace the ring gear at the same time you replace the starter motor.