GILLIG LOW FLOOR, Руководство по обслуживанию

Страница: 25 / 506

General Information
25
The starter is equipped with an overcrank protection system. A
temperature sensor in the starter prevents cranking when the starter
overheats. If this occurs, allow the starter to cool.
A runaway starter can overheat and start a fire. Power to the starter
must be shut off using the battery disconnect switch if the “Starter”
indicator lamp stays on after you release the starter button.
5. Check the oil pressure gauge (if equipped) immediately after the engine starts. The gauge should
show oil pressure within 15 seconds of starting. If the oil pressure gauge still reads zero after 15
seconds, shut the engine down immediately and begin troubleshooting.
If the oil pressure gauge reads zero after 15 seconds, or “Check Engine”
and/or “Stop Engine” indicator lamps remain lit after startup, shut the
engine down immediately.
Sufficient air pressure is needed for the brakes to work properly. The
recommended operating pressure range is 110 to 130 psi. Ensure both
needles on the air pressure gauge are above 110 psi before starting to
drive the bus.
6. Run the engine at Fast Idle or part throttle until the air pressure gauge shows at least 110 psi and
the engine coolant temperature gauge indicates a temperature of at least 140° F. It is best to let
the engine idle for 3 to 5 minutes before moving the bus. Do not idle the engine for extended
periods of time (10 minutes or more). If prolonged idling is necessary, use the Fast Idle setting.