GILLIG LOW FLOOR, Руководство по обслуживанию

Страница: 415 / 506

45
Electrical System
License Plate Light
A license plate lamp is mounted above the license plate
in the license plate holder in the rear engine access
door. The lamp is energized when the ignition rotary
switch is in any position beyond the “OFF” position.
Refer to the “License Plate Lamp” wiring diagram in
the Electrical Schematics Manual for information on
the circuits and connectors used with this lamp.
To replace the lamp:
1. Wedge a screwdriver between one of the ends
of the lamp unit and the bracket that holds it
(Figure 9-55).
2. Carefully pry the lamp unit away from its
bracket.
3. Remove the old lamp unit and replace it with a
new one.
Marker, Clearance, and Identification Lights
Marker lights are located at different points around the bus providing demarcation for surrounding
evening traffic. The clearance and side-mounted turn signal lights serve also as marker lights. Marker,
clearance, and identification lights, turn on when the ignition rotary switch is in the or position.
Refer to the “Exterior Lighting” wiring diagram in the Electrical Schematics Manual for further infor-
mation on the circuits and connectors used with these lights.
Marker, Clearance or Identification Lamp Assembly Replacement
These lights are the LED type so there are no bulbs to replace. If a lamp assembly fails, the entire assem -
bly must be replaced.
To replace the lamp assembly:
1. Using an Allen head screwdriver, remove the two button head hex socket screws attaching the as-
sembly to the coach body surface.
2. Pull the unit out far enough to reach the rear of the lamp.
3. Mark the wiring connectors prior to removing them for purposes of reinstallation.
4. Remove the wiring connectors from the lamp terminals.
5. Install the new lamp assembly, bulb, or lens by reversing the order of component removal.
Lamp
Bracket
Figure 9-55, License Plate Light