GE FQ000040, Руководство по обслуживанию

Страница: 513 / 698

GE
D
IRECTION
FQ091019, R
EVISION
2 V
IVID Q
N S
ERVICE
M
ANUAL
Chapter 8 - Replacement Procedures 8-7
.
Figure 8-7 Removing the Hard Disk
8-2-3-5 Hard Disk Installation Procedure
NOTE: When replacing the BEP or Hard Disk, one must either obtain new access codes that will fit the
system ID which is programmed on the BEP, or program the BEP system ID to fit the access
codes already registered in the Hard Disk. Only qualified personnel should perform these tasks.
1) Place the new hard disk in position in the hard disk module holder - see Figure 8-7 on page 8-7 .
2.) Return and fasten the two screws (previously removed) to secure the Hard Disk in position - refer
to Figure 8-6 on page 8-6 .
NOTE: The formatting process limits the size of the partition “E:\” on the hard disk to approximately
120GB.
To identify which hard disk is installed on your system, boot up the system and enter the BIOS
configuration as described in
"Setting the BIOS" on page 8-114 .
The hard disk is identified by the Primary Master: ST9500325AS-(PM) - see Figure 8-8 .
NOTICE
If the supplied SATA hard disk is not formatted, a Formatting Utility CD will be supplied as part of the
kit - perform the Hard Disk Formatting procedure as described in
"Formatting the Hard Disk" on page
8-8.
NOTICE
For BT12 systems, use BT12 software media to perform the Hard Disk Formatting procedure .
Figure 8-8 BIOS Main Screen