GE FQ000040, Руководство по обслуживанию

Страница: 86 / 698

GE
D
IRECTION
FQ091019, R
EVISION
2 V
IVID Q
N S
ERVICE
M
ANUAL
3-14 Section 3-5 - Preparing for Installation
3-5-3-1 Damage Inspection Checklist (cont’d)
Table 3-8 Damage Inspection Checklist - SafeLock Cart (optional)
Step Item Recommended Procedure
1
Probe Holders Clean the gel wells with warm water and a damp cloth to remove all traces of gel.
2
Peripheral
Power and USB
Audio Panels Check the panel connectors for bent pins, loose connections and loose or missing
hardware. Screw all the cable connectors tightly to the connector sockets on the
panel. Verify that the labeling is in good condition.
3
Covers Check that all screws are in place, all chassis and internal covers are installed.
4
Peripherals
Check and clean the peripherals in accordance with the manufacturer’s directions.
To prevent EMI or system overheating, dress the peripheral cables inside the
peripheral cover.
5
AC System
Check the AC board connectors and the associated cabling for good connection
and proper insulation. Verify that the connections are secured.
6
Power Cord
Check the power cord for cuts, loose hardware, tire marks, exposed insulation, or
any deterioration. Verify continuity.
Tighten the clamps that secure the power cord to the unit and the outlet plug to the
cord. Replace the power cord and/or clamp, as required.
7
Front Castors
Check that the front castors can swivel, and can be placed in the locked position
by pressing the foot brake lever (lower)
down on each castor. Check that the upper
lever releases the SafeLock Cart wheel lock on each castor wheel.
8
Rear Castors Check that the rear castors can roll and swivel.

Clamp securing power cord