Xerox WC5545F, Service Manual

Page: 725 / 2320

August 2007
2-533
WorkCentre 5687 Family
11F-170
Status Indicator RAPs
Skewed Booklet Crease
Figure 3, open out the booklet at the centre page and press it onto a flat surface. Measure the
amount of booklet skew.
Figure 3 Booklet skew
If the booklet skew does not conform to the specification in Table 4, check the operation of the
BM stack hold solenoids, refer to the 11-065-170, 11-383-170 HCSS Booklet Back Stop Failure
RAP. If the stack hold solenoids are operating correctly, check for any contamination or debris
in the compiling area of the BM, that could cause the mis-alignment.
Booklet Crease is Off Centre
Figure 4, open out the booklet at the centre page and press it onto a flat surface. Measure the
position of the booklet crease.
Figure 4 Booklet crease position
Table 4 Skew tolerance
Paper weight
Paper size A4,
8.5x11in,
8.5x13in or
8.5x14in Paper size A4,
8.5x11in,
8.5x13in or
8.5x14in
Paper size A3
or 11x17in Paper size A3
or 11x17in
-
95% of
booklets 99.7% of
booklets 95% of
booklets 99.7% of
booklets
80gsm (20lb) Less than
1.0mm Less than 2.5mm Less than
1.4mm
Less than
3.1mm
All other booklet
maker approved
weights in GP 20 Less than
1.5mm Less than 3.0mm Less than
2.1mm
Less than
3.6mm
The amount of skew is the difference
between the two measurements
Table 5 Crease position and tolerance
Paper size Edge to crease measurement
A4 148.5 +/- 1.5mm
A3 210 +/- 1.5mm
8.5x11 inch 139.5 +/- 1.5mm
8.5x13 inch 165.1 +/- 1.5mm
8.5x14 inch 178.0 +/- 1.5mm
11x17 inch 216.0 +/- 1.5mm
Measure from the booklet
edge to the crease