Xerox WC5545F, Service Manual

Page: 404 / 2320

August 2007
2-212
WorkCentre 5687 Family
08-150, 08-151, 08-150A, 08-151A
Status Indicator RAPs
08-150, 08-151 Registration Jam Entry RAP
08-150 The lead edge of the paper failed to actuate the registration sensor within the correct
time after the paper was released from the wait point.
08-151 The trail edge of the paper was late to the registration sensor after the registration
clutch, CL08-070 on.
Procedure
Identify the speed of the machine, refer to SCP 7 Machine features. Perform one of the steps
that follow:
• If the speed of the machine is 32-55 ppm, go to 08-150A, 08-151A Registration Jam RAP
(32-55 ppm)
• If the speed of the machine is 65 - 87 ppm, go to 08-150B, 08-151B Registration Jam
RAP (65-87 ppm).
08-150A, 08-151A Registration Jam RAP (32-55 ppm)
08-150 The lead edge of the paper failed to actuate the registration sensor within the correct
time after the paper was released from the wait point.
08-151 The trail edge of the paper was late to the registration sensor after the registration
clutch, CL08-070 on.
Initial Actions
• Make sure that the correct RAP is used. To identify the correct RAP to use, go to the 08-
150, 08-151 Registration Jam Entry RAP.
• Check the condition of the paper in all trays. Refer to IQ1 and GP 20.
• Check for obstructions in the paper path.
• Check the registration sensor actuator and the wait sensor actuator, Figure 1.
• Check that the left hand door is latched correctly.
• Check that the interlock cover has not come loose, PL 7.30 Item 23. Push the cover to the
right and tighten the screws
• Check that the short paper path assembly latches without excessive force, PL 10.25 Item
1. Go to REP 10.1. In Replacement Step 5, check the latch mechanism.
• If the fault code is 08-151 and two sheets of paper are jammed at the registration rolls. Go
to OF8 Multifeed RAP.
• If the fault code 08-151 occurs from the bypass tray. Go to the 07C Bypass Tray RAP.
• If the power and control assembly has been moved prior to a 08-150. Check that PJ148 is
pushed fully home on the Main Drives PWB.
• Check the transport drive belt.
• Ensure that all connectors on the tray 1 and 2 Control PWB, PL 7.10 Item 2 and on the
IOT PWB, PL 1.10 Item 2 are correctly and securely seated.
Procedure
NOTE: Ensure that the front door interlock is cheated when ch24V components.
Enter dC330 code 08-150 registration sensor, Q08-150. Press Start. Open the left hand door
and manually actuate the registration sensor. The display changes.
Y
N
Go to Flag 1. Check Q08-150. Refer to:
• GP 11 How to check a Sensor.
• P/J16, IOT PWB.
• 01D +3.3V Distribution RAP.
• 01B 0V Distribution RAP.
Install new components as necessary:
• Registration sensor, (32-55 ppm) PL 8.15 Item 3.
• Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL
1.10 Item 2.
Enter dC330 code 08-100 wait sensor, Q08-100. Press Start.
Open the left hand door and manually actuate the wait sensor. The display changes.