Xerox WC5545F, Service Manual

Page: 843 / 2320

August 2007
2-651
WorkCentre 5687 Family
11D-171
Status Indicator RAPs
If the top and bottom edge alignment does not conform to the specification in Table 2, check
the operation of the BM tampers, refer to the 11-066-171, 11-384-171 HVF BM Tamper Failure
RAP. If the tampers are operating correctly, go to ADJ 11.5-171 Booklet Tamping and check the
tampers are correctly adjusted.
If the booklet skew does not conform to the specification in Table 4. Perform the following:
• Check the operation of the BM stack hold solenoids, refer to 11-065-171, 11-383-171 HVF
Booklet Back Stop failure RAP.
• If the stack hold solenoids are operating correctly, check for contamination or debris in the
compiling area of the BM that could cause the mis-alignment.
• Perform ADJ 11.4-171 Crease Blade Position.
Open Side Edge Alignment
Figure 2, open out the booklet at the centre page and press it onto a flat surface. Measure the
mis-alignment of the open side edges of the booklet.
Figure 2 Open side edge alignment
If the open side edge alignment does not conform to the specification in Table 3, check the
operation of the BM stack hold solenoids, refer to the 11-065-171, 11-383-171 HVF Booklet
Back Stop Failure RAP. If the stack hold solenoids are operating correctly, check carefully for
any contamination or debris in the compiling area of the BM, that could cause the mis-align-
ment.
Badly Formed Booklet Staples
If the booklet staples are not formed correctly, perform ADJ 11.3-171 Staple Anvil Alignment.
Booklet Compiler is Not Correct
If the page order of the booklets is not correct, perform ADJ 11.6-171 Booklet Compiling Posi-
tion.
Table 3 Open side edge alignment
Paper weight 95% of booklets 99.7% of booklets
80gsm (20lb) 1mm 2mm
All other BM approved weights in GP 20 2mm 3mm
Measure the total scatter