Xerox WC5545F, Service Manual

Page: 1972 / 2320

August 2007
6-80
WorkCentre 5687 Family
dC131a
General Procedures & Information
09-128 PC From Flash Or
Ram For development only.
Alters process control fac-
tors source from either flash
or NVM. 0 to 1 0
09-129 Disp Mot Min Run Dispense motor minimum
run time for toner dispense. 100 to 1000ms 200
09-130 Disp Mot Ramp Up Dispense motor ramp up
time.
10 to 20000ms 30
09-131 Disp Mot Run On Dispense motor run on
time. 10 to 20000ms 320
09-132 Nh Vac Fan Off To
Off Tme Nohad vacuum fan on time. 0 to 100ms 32/38=61
45/55/65/75/
87=43
09-133 Nh Vac Fan Off To
On Tme Nohad vacuum fan off time. 0 to 100ms 32/38=42
45/55/65/75/
87=29
09-134 Rep Del Rate Adj
Factor Replenisher delivery rate
adjustment factor. 95 to 115% 100
09-135 TggAdaptiveEn-
able Enables and disables the
replenisher delivery rate
adjustment feature 0=disabled
1=enabled 1
09-267 Humidity Sensor
Fault Humidity sensor fault. 0 0
09-268 Dev Temp Sensor
Fault Developer temperature sen-
sor fault. 0 0
09-269 AmbTempSensor-
Fault Ambient temperature sen-
sor fault. 0 0
09-271 Developer age Developer material age. 0 to
2147483647
pages 0
09-273 OCT Full Filter
Page Count OCT 90% full filter. 0 to 50 pages 30
09-274 Chute Bias inter
doc Chute bias inter document
level. Unsigned no. in NVM
table (displayed on GUI) to
be converted to signed no.
over range of -500 to +900
(Volts) by subtraction of 500
from table value. 0 to 1400V 0
09-275 TC Setup Target
Voltage Toner concentration setup
target voltage. 0 to 500
(mVx10) 32/38/45=0
55/65/75/
87=185
09-276 TC lockout high CSF NVM lockout for TC
process control. Failure =
high. 0 0
Table 8 NVM chain 9
Location NVM Name NVM Description Value Default
09-277 Int Man Clean
Enable Interim manual charge
scorotron cleaning ennoble-
ment flag. 0=disabled
1=enabled 32/38=0
45/55/65/75/
87=1
09-278 Auto Clean Enable Auto charge scorotron
cleaning ennoblement flag.
0=disabled
1=enabled 32/38=0
45/55/65/75/
87=1
09-279 Charg Clean Cout
Enable Charge cleaner count
enable. 0=disabled
1=enabled 0
09-280 Inactivity Limit IOT Machine inactivity limit held
on the IOT PWB.
120 to 4320
minutes 300
09-281 TDT AutoClean
Enable Transfer/Detack auto clean
enable flag. 0=disabled
1=enabled 1
09-282 Dev Age Time
Based Developer age - time
based. 0 to
2147483647
seconds 0
09-312 Grid Voltage Offset Used to display the grid
voltage offset value held in
the XRU CRUM.
0 to 40 = 0 to
+40v
129 to 168 = -1
to -40v 0
09-313 Grid Volt Adj Nom Used to display the grid
voltage adjusted nominal. 110 to 740 32/38=420
45/55=430
65/75/87=420
09-314 Grid Volt Adj
Enable Used to enable grid voltage
nominal adjustment. 0=disabled
1=enabled 1
09-315 Grid Curr Scaler Used to display the grid cur-
rent scaler value held in the
XRU CRUM. 0 0
09-316 Grid Curr Adj Nom Used to display the grid cur-
rent adjusted nominal.
250 to 4500mA 32/38=800
45/55/65/75
=2050
09-317 Grid Curr Adj
Enable Used to enable grid current
nominal adjustment. 0=disabled
1=enabled 1
09-318 ROS Laser Scaler Used to display the ROS
laser light level scaler value
held in the XRU CRUM.
0 0
09-319 ROS Laser Adj
Nom Used to display the ROS
laser light level adjusted
nominal. 750 to 9000 32/38=3471
45/55=2250
65/75 =2400
09-320 ROS Laser Adj
Enable Used to enable ROS laser
light level nominal adjust-
ment. 0=disabled
1=enabled 1
Table 8 NVM chain 9
Location NVM Name NVM Description Value Default