Xerox WC5545F, Service Manual

Page: 664 / 2320

August 2007
2-472
WorkCentre 5687 Family
11-066-170, 11-384-170
Status Indicator RAPs
11-066-170, 11-384-170 HCSS BM Tamper Failure RAP
11-066-170 The HCSS BM tamper 1 failed to clear the home sensor.
11-384-170 The HCSS BM tamper 1 is not at the home sensor.
Initial Actions
• Check for a jam or other obstruction that could prevent the tamper mechanism from mov-
ing.
• Check for damaged tamper components, PL 11.81.
Procedure
Enter dC330 code 11-384 Actuate the BM tamper 1 home sensor, Figure 1. The display
changes.
Y
N
Go to Flag 1, check the sensor, Q11-384.
Refer to:
• GP 11, How to Check a Sensor.
• P/J556, BM PWB.
• 11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary:
• BM PWB, PL 11.86 Item 10.
• BM tamper 1 home sensor, PL 11.81 Item 1.
Enter dC330, code 11-066 to run the BM tamper 1 motor, MOT 11-066, Figure 1. The motor
runs.
Y
N
Go to Flag 2 and Flag 3, check the motor, MOT 11-066.
Refer to:
• GP 10 How to Check a Motor.
• P/J554, BM PWB.
• 11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary:
• BM PWB, PL 11.86 Item 10.
• BM tamper 1 motor, PL 11.81 Item 3.
The fault may be intermittent, check for damaged wiring or bad connectors, REP 1.2. If neces-
sary install new components:
• BM tamper 1 home sensor, PL 11.81 Item 1.
• BM tamper 1 motor, PL 11.81 Item 3.
• BM PWB, PL 11.86 Item 10.
Figure 1 Component location
BM tamper 1 home sensor, Q11-384
BM tamper 1 motor,
MOT11-066