Xerox WC5545F, Service Manual

Page: 350 / 2320

August 2007
2-158
WorkCentre 5687 Family
07-354
Status Indicator RAPs
07-354 Tray 2 Elevator Lift Failure RAP
07-354 Tray 2 stack height sensor did not actuate within the correct time after the feed / eleva-
tor motor turned on.
Initial Actions
• Check for obstructions behind the tray.
• Ensure that the tray is pushed fully home.
Check the stack height mechanism actuator on the back of the tray, Figure 1.
• Check the drive gears and coupling on the tray.
• Check the elevator drive coupling on the feeder assembly.
Procedure
Enter dC330 code 07-337 tray 2 stack height sensor, Q07-337. Press Start. Pull out tray 1 and
push fully home. The display changes
Y
N
Go to flag 2. Check Q07-337. Refer to:
• GP 11 How to Check a Sensor.
• P/J275, Tray 1 and 2 control PWB.
• 01E +5V Distribution RAP.
• 01B 0V Distribution RAP.
Install new components as necessary:
• Tray 2 stack height sensor, PL 8.26 Item 8.
• Tray 1 and 2 control PWB, PL 7.10 Item 2.
CAUTION
To prevent damage to the elevator and paper feed mechanism, the paper tray must be pulled
out before MOT07-020 is run in diagnostics.
Enter dC330 code 07-020 tray 1 feed / elevator motor, MOT07-020. Pull out tray 1. Press
Start. The motor runs
Y
N
Go to flag 3. Check MOT07-020. Refer to:
• GP 10 How to Check a Motor.
• P/J275, Tray 1 and 2 control PWB.
• 01G +24V Distribution RAP.
• 01B 0V Distribution RAP
Install new components as necessary:
• Tray 2 Feed / elevator motor, PL 8.26 Item 6.
• Tray 1 and 2 control PWB, PL 7.10 Item 2.
Perform the following:
•
Check the feeder / elevator motor drive gears, Figure 1.
• Check the tray 2 stack height mechanism on the feeder assembly,
If the fault still occurs then go to 07A Tray 1 and Tray 2 False Paper Level RAP.
Figure 1 Component location
Drive gears
Stack height mechanism
actuator