Xerox WC5545F, Service Manual

Page: 482 / 2320

August 2007
2-290
WorkCentre 5687 Family
11-024-110, 11-025-110
Status Indicator RAPs
11-024-110, 11-025-110 Paddle Roll Failure RAP
11-024-110 The paddle is not at the home position.
11-025-110 The paddle fails to rotate.
NOTE: The paddle is in the home position when the sensor flag is located between the sensor
jaws. If a jam occurs in the compiler, bin 1 will not be available.
WARNING
Take care not to topple the LCSS.
The LCSS is unstable when un-docked from the machine.
Do not show the customer how to un-dock the LCSS.
Initial Actions
Check the following:
• That there is no paper or other obstructions in the vicinity of the paddle.
• The paddle roll position sensor bracket is holding the sensor in the correct position, i.e.
the flag is in the middle of the sensor gap and the sensor does not touch any moving com-
ponents.
• Check that paper type is set correctly. If heavyweight paper is used but not set in the UI,
the compiler capacity can be exceeded. Refer to 11J-110 Mis-Registration in Stapled Sets
and Non-stapled Sets RAP.
• Check the position of the paddles. With the paddle roll in the home position both sets of
paddles must be within the output cover, if they are not, refer to REP 11.12-110 Paddle
Wheel Shaft Assembly. If any of the paddles are out of alignment to other paddles, install
a new paddle wheel shaft assembly, PL 11.8 Item 4.
• 2K LCSS PWB DIP switch settings, refer to 11F-110 2K LCSS PWB DIP Switch Settings
RAP.
Procedure
NOTE: All 2K LCSS interlocks must be made to 24V to the motors.
NOTE: In diagnostics, actuating any 2K LCSS sensor or switch can change the displayed state
on the UI. Make sure that the correct sensor or switch is tested.
Enter dC330, codes 11-024, paddle home position and 11-025, paddle run. The paddle
rotates correctly.
Y
N
Go to Flag 2. Check the paddle motor, MOT 11-024.
Refer to:
• 11G-110 2K LCSS PWB Damage RAP.
• GP 10, How to Check a Motor.
• Figure 1.
• P/J310, 2K LCSS PWB.
• 11D-110 2K LCSS Power Distribution RAP
Repair or install new components as necessary:
• Paddle motor, PL 11.8 Item 10.
• 2K LCSS PWB, PL 11.26 Item 1.
Enter dC330, code 11-025 and stack the code 11-326, to actuate the paddle roll position sen-
sor Q11-326. The display cycles high/low.
Y
N
Go to Flag 1 and check Q11-326.
Refer to:
• 11G-110 2K LCSS PWB Damage RAP.
• GP 11, How to Check a Sensor.
• Figure 1.
• P/J314, 2K LCSS PWB.
• 11D-110 2K LCSS Power Distribution RAP
Repair or install new components as necessary:
• Paddle roll position sensor, PL 11.8 Item 11.
• 2K LCSS PWB, PL 11.26 Item 1.
Perform SCP 6 Final Actions.
Figure 1 Component location
Paddle motor
MOT11-024
Paddle roll position
sensor
Q11-326
A
A