Xerox WC5545F, Service Manual

Page: 635 / 2320

August 2007
2-443
WorkCentre 5687 Family
11-005-170, 11-006-170, 11-310-170, 11-311-170
Status Indicator RAPs
11-005-170, 11-006-170, 11-310-170, 11-311-170 Compiler
Carriage Front Tamper Move Failure RAP
11-005-170 The compiler carriage front tamper fails to move to the front position.
11-006-170 The compiler carriage front tamper fails to move to the rear position
11-310-170 The compiler carriage front tamper is not at the front home position.
11-311-170 The compiler carriage front tamper is not at the rear home position.
Initial Actions
• Figure 1, check for damage or obstructions that would prevent the front tamper assembly
from operating correctly. If necessary, install a new compiler carriage assembly, PL 11.72
Item 1.
• Jams can be caused if the tray settings do not match the paper in the trays. Make sure the
tray settings are correct.
Procedure
NOTE: All HCSS BM interlocks must be made to 24V to the motors.
Enter dC330, codes 11-005 tamper motor front move, then 11-003 tamper motor front home,
Figure 1. The front tamper moves between the inboard and home positions.
Y
N
Go to Flag 2. Check the motor, MOT11-003.
Refer to:
• GP 10, How to Check a Motor.
• P/J404, Carriage PWB.
• 11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary:
• Carriage PWB, PL 11.72 Item 5.
• Front tamper motor, PL 11.72 Item 10.
Enter dC330, code 11-310, actuate the front tamper home sensor, Figure 1 by using the
stacked codes, 11-003 and 11-005 to move the tamper. Observe the display. The display
changes.
Y
N
Go to Flag 1. Check the sensor, Q11-310.
Refer to:
• GP 11 How to Check a Sensor.
• P/J407, Carriage PWB.
• 11C-170, HCSS BM Power Distribution RAP.
Install new components as necessary:
• Carriage PWB, PL 11.72 Item 5.
• Compiler carriage assembly, PL 11.72 Item 1.
Go to Flag 3. Check the connectors and harness between P/J412 and P/J432. Also check the
connectors and harness between P/J401 and P/J428, refer to GP 7. The wiring and con-
nectors are good.
Y
N
Repair the wiring, REP 1.2, or install new components as necessary.
Perform SCP 6 Final Actions.
Figure 1 Component location
Front tamper home
sensor, Q11-310
Front tamper motor,
MOT 11-003
Compiler carriage assembly
Front tamper assembly
A
A