Thermo Scientific
imPULSE S.U.M. with Touchscreen Console User’s Guide
|
50
Chapter 3
|
Touchscreen Console setup
3.4.4 Configuring the Timer module
Because the Timer module has only
Start
and
Stop
functionality, there
are no fields to configure.
1. Select
Configure
to open the Timer Settings screen.
2. Select
Done
to return to the Home screen.
Calibration
Set up one-point mass calibration to determine the accuracy of load
cell mass readings.
1. If you would like to set up a mass calibration, touch the
Calibration
field.
2. Follow the calibration instructions in Chapter 4—Calibration
procedures.
3. Touch
Done
to return to the Home screen.
3.4.5 Configuring the PCD module
The PCD module should only be used on systems where the PCD is
present. Use the following information and steps to configure the PCD
module.
To begin, locate the PCD Pressure module on the Touchscreen
Console Home screen, and touch
Configure
. The PCD Module
Configuration screen will appear (Figure 3.21).
Note:
You can touch
Done
at the bottom of the Configuration screen
at any time to save your current settings and so you can resume later.
