Thermo Scientific
imPULSE S.U.M. with Touchscreen Console User’s Guide
|
70
Chapter 3
|
Touchscreen Console setup
3.4.10 Configuring the Temperature module
Use the following information and steps to configure the Temperature
module. To begin, locate the Temperature module on the Touchscreen
Console Home screen, and touch
Configure
. The Temperature Module
Configuration screen will appear (Figure 3.44).
Note:
You can touch
Done
at the bottom of the Configuration screen
at any time to save your current settings and so you can resume later.
Figure 3.43. Pump selection on the Harvest Module
Configuration screen.
4. Enter your desired values for the following fields:
•
Fluid target:
The total amount of liquid you would like to pump out
of the BPC.
Note:
This is the only option available if there is not at
least one pump set up.
•
Stage 1 flow rate:
The rate you would like to use when initially
harvesting from the BPC (in L or kg per minute).
•
% Filled before stage 2:
The percentage of liquid that should be
pumped out of the BPC before the pump moves to Stage 2.
•
Stage 2 flow rate:
The rate you would like to use when finishing the
harvesting process. The Stage 2 flow rate should be significantly
slower than Stage 1 to prevent overharvesting.
5. Touch
Done
to return to the Home screen.
Optional fields
There are no optional fields for Harvest Module Configuration.
