Thermo Scientific
imPULSE S.U.M. with Touchscreen Console User’s Guide
|
55
Chapter 3
|
Touchscreen Console setup
3.4.6 Configuring the BPC Pressure module
The BPC module should only be used on systems where a PCD
is not present. To begin, locate the BPC Pressure module on the
Touchscreen Console Home screen, and touch
Configure
. The BPC
Module Configuration screen will appear (Figure 3.25).
Note:
You can touch
Done
at the bottom of the Configuration screen
at any time to save your current settings and so you can resume later.
Figure 3.25. BPC Module Configuration screen.
Required fields
Units
Enter the units you would like to use when filling the BPC with air:
millibar (mbar) or psi. By default, the units are set to
PSI
.
4. To change the units, touch the
Units
field.
5. Touch PSI or mbar to use that unit of measurement.
– Once you make a selection, the BPC Module Configuration
screen will reappear and your changes will be reflected in the
Units
field.
