Thermo Scientific
imPULSE S.U.M. with Touchscreen Console User’s Guide
|
94
Chapter 3
|
Touchscreen Console setup
Figure 3.73. Aux Input Module Configuration screen.
Note:
You can touch
Done
at the bottom of the Configuration screen
at any time to save your current settings and so you can resume later.
Required fields
Units
Enter the units that you would like the Touchscreen Console to use for
the auxiliary input module.
1. Touch the
Units
field.
2. On the screen that appears, Touch the
Units to display field
. Use
the alphanumeric keyboard to type the units you would like to use
and touch
Enter
.
3. When you are finished, touch
Done
. The system will confirm the
settings. Touch
Done
again to return to the Auxiliary Input Module
Configuration screen.
Scaling
Enter the scaling you would like the Touchscreen Console to use
between the mA signal and the units you have entered.
3.4.15 Configuring the Auxiliary Input module
Use the following information and steps to configure the Auxiliary
Input 2 module. Auxiliary Input 1 is reserved for the laser distance
measurement sensor and is not used in the same way. To begin, locate
the Auxiliary Input module on the Touchscreen Console Home screen,
and touch
Configure
. An Auxiliary Output Module Configuration screen
will appear (Figure 3.73).
