Thermo Scientific
imPULSE S.U.M. with Touchscreen Console User’s Guide
|
76
Chapter 3
|
Touchscreen Console setup
3.4.11 Configuring the pH module
Use the following information and steps to configure the pH module.
To begin, locate the pH module on the Touchscreen Console Home
screen, and touch
Configure
. The pH Module Configuration screen will
appear (Figure 3.53).
Note:
You can touch
Done
at the bottom of the Configuration screen
at any time to save your current settings and so you can resume later.
Figure 3.53. pH Module Configuration screen.
Required fields
pH sensors available
Select which pH sensors you would like to make available for use. You
may select pH1, pH2, or both.
1. Touch the
pH Sensors Available
field.
2. On the screen that appears (Figure 3.54), select the pH sensor(s)
you would like to have available for use. You may select either
pH1
,
pH2
, or both.
