Thermo Scientific
imPULSE S.U.M. with Touchscreen Console User’s Guide
|
25
Chapter 2
|
Hardware installation
Figure 2.16. Connecting pumps to the
Touchscreen Console.
Connect the pumps
1. Plug the communication cables from the pump(s) into the
pump/aux out ports on the back of the Touchscreen Console, and
use the supplied tool to tighten (Figure 2.16).
2. Plug the pumps into the proper power source.
Note:
To calibrate
pumps after they have been set up, first become familiar with
sections 3.1–3.2. Then see section 4.1—Calibrating pumps.
Verify the laser distance sensor is connected
1. Ensure the laser distance sensor located at the bottom of the drive
box (Figure 2.17) is connected to the Aux In 1 port on the back of
the Touchscreen Console (Figure 2.18).
Figure 2.17. Laser distance sensor
located at the bottom of the drive
box.
Figure 2.18. Drawing showing the location of
the Aux In 1 port.
