Still LXT 120, Original Instructions Manual

Page: 259 / 324

–
Guide the tension belts around the truck
rear as shown in the adjacent diagram.
–
Route the tension belts towards the front
on the right-hand and left-hand sides and
secure them to the specified lashing points
on the transport vehicle.
–
Where tension belts are routed over body
edges, cushion these areas with protection,
such as rubber mats.
Loading the industrial truck by
crane
NOTE
Crane loading is intended only for transporting
the industrial truck for its initial commission-
ing. For operating conditions that frequently
require crane loading, consult the authorised
service centre.
Industrial trucks may only be crane-loaded by
persons with sufficient experience of the suita-
ble harnesses and hoists.
DANGER
Risk of death from suspended loads!
–
Never enter the area below the industrial truck
suspended from the crane.
DANGER
Risk to life due to the harnesses snapping!
Sharp edges can damage harnesses.
–
Protect harnesses from sharp edges.
–
Harnesses must be designed for a load capacity
that is sufficient for the weight of the industrial
truck. The harnesses must be approved for a sin-
gle load of at least 4 t.
–
Only use harnesses with a sufficient load capaci-
ty.

Operation
4
Transporting the industrial truck
247 50078078001 EN - 07/2022 - 04