Omron NJ501-4300, Manual

Page: 239 / 336

6 - 35
6 Troubleshooting
NJ-series NJ Robotics CPU Unit User’s Manual (W539)
6-2
Er
ro
r Descript
ion
6
6-
2-2 Err
or D
escriptions
Event name Target Position Setting Out of Range Event code 54780000 hex
Meaning The parameter specified for the Position input variable to a motion control instruction is out of range.
Source
Motion Control Function Module
Source details
Axis/axes group Detection
timing At instruction
execution
Error
attributes
Level
Minor fault
Recovery
Error reset
Log category
System
Effects User program
Continues.
Operation
If "axis" is given for the source details, operation is
not possible for relevant axis. Relevant axis deceler-
ates to a stop if it is in motion.
If "axes group" is given for the source details, opera-
tion is not possible for relevant axes group. Relevant
axes group decelerates to a stop if it is in motion.
System-
defined
variables
Variable Data type Name
_MC_AX[*].MFaultLvl.Active BOOL Axis Minor Fault Occurrence
_MC_GRP[*].MFaultLvl.Active BOOL Axes Group Minor Fault Occur-
rence
Cause and
correction
Assumed cause Correction Prevention
Instruction input parameter
exceeded the valid range of the
input variable. Correct the parameter so that the
valid range of the input variable is
not exceeded for the relevant
instruction. Set the input parameter to the
instruction so that the valid range
of the input variable is not
exceeded.
The target position of a Rotary
Mode axis is not within the ring
setting range. Correct the target position of the
Rotary Mode axis to within the ring
setting range. Set the target position of the
Rotary Mode axis to within the ring
setting range.
Attached
information
Depends on the source details.
Axis: None
Axes group: Element number that is out of range in the
Position input variable to the instruction.
Precautions/
Remarks None