73
Default setting：[SD：Operate smooth drive]
•
When operate smooth drive function、set ［SD］side.（Initialization）
•
When no operate smooth drive function, set ［OFF］side.
・Smooth drive function will not work when set over 10 divide division number.
Might be ignored to set［SD］.（Same as［OFF］operation）
3.7 Units setting function
No need difficulty change from pulse to actual displacement.
Units setting must be first for each setting parameter. Follow the below.
① Units setting（pulse, μm, mm, deg, mrad）
②
Set 1 pulse displacement at the full step（Basic resolution）set.
③
Set the division number（1/1～1/250）
④
１pulse displacement（Automatically calculated from ①～③）
Example） In case of set the stage：KXC06020-G（1μm／pulse）to mm.
Units：mm
1 pulse displacement at the full step：０．００１（mm）
Division number：１／２０
１pulse displacement：０．００００５（mm）
※
After setting, can use operate the setting units for all position data (except speed table).
※
In case of Sine Motion Stage（KRB04017, KRB06011, KGB07）, can use only
“
PULSE
”
as
unit setting.
Smooth drive changing-over switch
Summary of Contents for DS102MS
Page 166: ...166...
