InfoPrint 5504-R40, User Manual

Page: 94 / 402

94
Chapter 3
QUICK SETUP
QUICK SETUP
QUICK
SETUP
(from page 82)
Print
Intensity
Print
Speed
Print
Mode
8
-3*
-15 to 15
6 ips*
1 ips to 10 ips
1
Transfer*
Direct
Media
Handling
Tear-Off Strip*
Tear-Off
Peel-Off
Cut
Continuous
Paper Feed
Shift
0.00 inches*
2
-1.00 to X inches
3
Label
Length
9
4 or 6 inches*
2, 4
00.1 to 99.0 inches
5
Label
Width
9
4.1, 6.6, or 8.5 inches*
2, 4
00.1 to 8.5 inches
4
Ver Image
Shift
0.00 inches
2
-1.00 to X inches
3
Hor Image
Shift
0.00 inches*
2
-1.00 to 1.00 inches
Orientation
Portrait*
Landscape
Inv. Portrait
Inv. Landscape
Gap/Mark
Sensor
6
Disable
Mark
Gap
Advanced Gap*
Advanced Notch
Auto Calibrate
Run Calibrate
Validator
Funct.
7
Enable*
Disable
Active IGP
Emul
PGL*
ZGL
TGL
IGL
STGL
DGL
IEGL
MGL
VGL
Save Config.
1*
1-8
NOTES:
* = Factory Default
1
Maximum value depends on the printer model width (4, 6, or 8 inches) and printhead (203 or 300 dpi).
2
You can change the unit value from inches to millimeters under Units (in MEDIA CONTROL) when Admin User is
enabled.
3
Based on the current value setting for the Label Length (in QUICK SETUP), up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the printer model (see Appendix A, “Specifications”).
5
Maximum value depends on model width and size of DRAM installed (see Appendix A, “Specifications”).
6
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown in Table 6 on page 127. If you change the
Gap/Mark Sensor or Paper Out Sensor, you must recalibrate the media.
7
This menu appears only if a validator is installed.
8
This menu will not appear on Direct Thermal only printers.
9
Resolution changes based on “Label Resolution” menu under MEDIA CONTROL if Small Label Printer is installed.
10
xxx represents the emulation name selected in the Active IGP Emul menu.
11
This menu appears only if RFID is installed and there is no CST bundle in the Flash File System.
12
This menu appears only if RFID is not installed and there is a CST bundle in the Flash File System.
Power-Up
Config.
Factory*
1-8
xxx
Diagnostics
10
Disable*
Enable
SMT: Status
11
Disable*
Enable
PAA: Select
Tool
12
None*
CST-1
CST-2