InfoPrint 5504-R40, User Manual

Page: 205 / 402

205
Host Form Length (VGL)
Sets the printer page size.
•
Enable . Sets the printer label size equal to Label Length from the host
form length command. (For more information, refer to the VGL
Programmer’s Reference Manual .)
•
Disable . Sets the printer label size equal to the Label Length set in the
front panel under the PRINTER CONTROL menu.
The factory default is Enable.
Host Override
Determines whether the printer accepts certain commands sent by the host,
or continues to use the current operator panel settings.
•
Disable . Allows these host commands to override operator panel
settings: line length, forms length, lines per inch (LPI), characters per inch
(CPI), print quality, and text orientation. Note the information appearing on
the message display may not match the data stream setting. No values
will change upon initial selection of the Disable option.
•
Enable . The operator panel settings override the host commands.
The factory default is Disable.
Host PI
•
Disable . The host does not send PI signals.
•
Enable . The host sends PI signals. The Data Bit 8 configuration option
must be disabled to transmit the PI line to the printer.
The factory default is Disable.
I-2/5 Selection
This option is added to be compatible with a special
IGP-X00 customization. Usually, if Interleaved 2/5 bar codes have an odd
number of digits, a leading zero is inserted in front of the data. However, this
special IGP-X00 customization gives you the option of adding a space
character at the end of the bar code instead.
•
Leading Zero . A leading zero is inserted in front of the data.
•
Trailing Space . A space is inserted at the end of the data instead of a
leading zero.
•
X2 DPD . When selected, I-2/5 bar code with a magnification X2 will use
the specially configured ratios 3:3:6:5 rather than 3:6:9:12 for
compatibility issues.
•
Modulo 7 CD . The I-2/5 bar code uses a modulo 7 check digit instead of
the default modulo 10 check digit.
The factory default is Leading Zero.