InfoPrint 5504-R40, User Manual

Page: 131 / 402

CALIBRATE CTRL Submenus
131
Pwr Up Action
•
Disable . No movement at power up.
•
Auto-Cal . When the printer is first powered on, it will complete its
initialization and self-tests and then perform an Auto Calibrate. Once the
Auto Calibrate is complete, the printer will momentarily display the
Sensed Distance determined by the Auto Calibrate.Auto-Cal will not be
performed if Ticket Save is set to Enable.
•
Seek TOF . Assumes user has already calibrated media and used gap/
mark sensor. This moves the media to TOF (Top of Form) at power up.
Seek TOF will not be performed if the Gap/Mark Sensor is set to Disable
or if the Ticket Save Mode is set to Enable.
The factory default is Auto-Cal.
NOTE: If Ticket Save mode is enabled, you will not be able to set Pwr Up
Action to Enable. A temporary message, “Disable/Ticket Save Mode”
will display.
HeadClose Action
Selects whether the printer performs a selected action after a print head open
fault condition is cleared.
•
Disable . No media motion after a print head open fault condition is
cleared.
•
Auto-Cal . Performs a media calibration every time the print head open
fault condition is cleared.
•
Seek TOF . Moves the media to TOF (Top Of Form) when the printhead is
closed. The media should already be calibrated using Gap/Mark sensor.
NOTE: A seek to TOF will not occur if Gap/Mark Sensor is set to Disable or
Ticket Save Mode is set to Enable.
The factory default is Disable.
NOTE: If Ticket Save Mode is enabled, you will not be able to set
HeadClose Action to Auto-Cal or Seek TOF. A temporary message,
“Disable/Ticket Save Mode” will display.
NOTE: If there is data pending (data in buffer) when the head open fault is
cleared, Auto-Cal and Seek TOF are ignored.