Installation:
1. Remove existing pallet assembly from the rotor
arm.
2. V-1000, attach the hat pallet assembly to the pallet
arm with the four 3/8 pallet leveling bolts, washers,
and nuts as shown (locking knob facing up and to
the left). Slide assembly onto the rotor arm.
V-2000, install the hat pallet assembly directly to
the top of the rotor arm.
3. Insert the screen side clamp assembly and screen
into the screen holder.
4. Setting Off Contact
V-1000, raise or lower the hat pallet assembly
by adjusting the nuts on 3/8 leveling bolts or
through the screen clamp assembly.
V-2000, Loosen slightly the main head bolts and
adjust with the left and right pitch knobs. Retighten
main head bolts after adjusting.
Operating:
1. Hook the back of the hat over the spring loaded ten-
sioner and pull the hat up over the pallet. If addi-
tional spring pressure is needed move spring mount
brackets to the lower set of holes in the vertical
support.
2. Lower the side clamp assembly with cap screen
over the hat. Slide side clamp assembly and
screen to position artwork over cap.
3. Set desired off contact and test print.
Note: Do not over tighten the bolt in the plastic hat pal-
let. Additional hat pallet shapes are shown on page 2
Cap Printing Attachment on V-1000
Cap Printing Attachment on V-2000
Rotor Arm
Hat Pallet Assembly
Spring loaded tensioner
Cap Screen
Spring loaded tensioner
Cap Screen
Rotor Arm
Screen Side
Clamp Assembly
Screen Side Clamp Assembly
Cap Printing Attachment
V-1000 & V-2000 Printers
Installation and Operating Instructions
Hat Pallet Assembly
Nut
Washer
Washer
Nut
Nut
Bolt
Pallet Arm
Vastex E-mail assistance
Purchasing & Product Info:
Electrical Support:
Tech Support, Mechanical Setup, and Operation
Screen Printing Issues & Support:
Doc # 01-08-041
1
