112 Link
Scheduler Configuration
multiplexing to the capacity of the access link is, with Release 2.10, just one of a variety of possible
configurations that you can set.
In a first step a minimal profile has to be created.
profile service-policy modem-512
rate-limit 512
source class local-voice
priority
source class local-voice
share 30
source class default
share 70
The next step is to apply the profile just created to the interface connected to the modem.
context ip
interface wan
…
use profile service-policy modem-512 out
If enough bandwidth is available the configuration could be even reduced as following. This
configuration assumes
profile service-policy modem-512
rate-limit 2048
source class local-voice
priority
source class local-voice
priority
source class default
15.3 Command Cross Reference
Comparing the SmartWare Release 2.10 with the Cisco IOS QoS software command syntax often
helps administrators to straightforwardly configure SmartNode devices. In Table 15-1 below the
Cisco IOS Release 12.2 QoS commands are in contrast with the respective SmartWare Release 2.10
commands.
Action
IOS command
SmartWare command
Specifies the name of the
policy map or profile to be
created or modified.
policy-map
policy-map-name
profile service-policy
profile-
name
Specifies the name of the
class map or class to be
created.
class-map
class-map-name
source class
class-name
For IOS specifies average or
peak bit rate shaping. For
SmartWare assigns the
average bit rate to a source.
shape
{average | peak}
cir
[bc]
[be]
rate
bit-rate
Software Configuration Guide Release 2.10, Revision 1.00
Summary of Contents for SmartWare Release 2.10
Page 2: ...2 Legal Notice Software Configuration Guide Release 2 10 Revision 1 00...
Page 15: ...Terms and Definitions 15 Software Configuration Guide Release 2 10 Revision 1 00...
Page 218: ...218 PPP Configuration no shutdown Software Configuration Guide Release 2 10 Revision 1 00...
Page 272: ...272 Tone Configuration Software Configuration Guide Release 2 10 Revision 1 00...