Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 132 / 357

132 Serial Port Configuration
Software Configuration Guide Release 2.10, Revision 1.00
Step 2 node (prt-ser)[ slot / port ]#encapsulation
framerelay
Sets the encapsulation for selected
interface to frame relay
Procedure
To enable a serial interface
Mode
Administrator execution
Command Purpose
Step 1 node (cfg)#port serial slot port Selects the serial interface on slot and
port
Step 2 node (prt-ser)[ slot / port ]#no shutdown Enable the interface
Step 3 node (prt-ser)[ slot / port ]#show port serial Displays the serial interface
configuration.
Example: Enabling an Interface
The example shows how to enable the built-in serial interface on slot 0 and port 0 of a SmartNode
2300 series device. Check that in the command output of
show port serial State is set to OPENED .
SN(cfg)# port serial 0 0
SN(prt-ser)[0/0]# no shutdown
SN(prt-ser)[0/0]# show port serial
Serial Interface Configuration
------------------------------
Port : serial 0 0 0
State : OPENED
Hardware Port : V.35
Transmit Edge : normal
Port Type : DTE
CRC Type : CRC-16
Max Frame Length: 2048
Recv Threshold
: 1
Encapsulation :
16.5 Configuring the Serial Encapsulation Type
The synchronous serial interface supports the Frame Relay serial encapsulation method.
To set the encapsulation method used by a serial interface, use the
encapsulation interface
configuration command.
Procedure
To set the encapsulation type of the serial interface for frame relay
Mode
Administrator execution
Command Purpose
Step 1 node (cfg)#port serial slot port Selects the serial interface on slot and
port