Inalp Networks SmartWare Release 2.10, Software Configuration Manual, Page: 326 / 357

326 VoIP Profile Configuration
SN(pf-voip)[Wire128~]# dtmf-relay
SN(pf-voip)[Wire128~]# dejitter-mode adaptive
SN(pf-voip)[Wire128~]# dejitter-max-delay 100
SN(pf-voip)[Wire128~]# voice-volume 20
SN(pf-voip)[Wire128~]# exit
SN(cfg)#
Afterwards we show the configuration and configure the ISoIP gateway to use the VoIP profile. As
aforementioned fax and data settings may be ignored.
SN(cfg)# show profile voip Wire128kbit
Profile Wire128kbit
------------------------------------------------------------------
dejitter settings: mode:
adaptive
max delay: 100 ms
max packet loss: 4
shrink speed: 1
grow step: 1
grow attenuation: 1
voice settings: hybrid loss: 6
non linear processor mode: adaptive
echo canceller:
enabled
silence compression: enabled
high pass filter: enabled
post filter: enabled
volume: 20 dBm
fax/data settings: transmission type: FAX
mode: voice-only
volume: -9.5 dBm
jitter periond: 0 ms
bypass coder: g711
error correction: disabled
fax settings: protocol: T.38-TCP
max bit rate: 9600 bit/s
data settings: modulation type: single-frequency
max bit rate: 9600 bit/s
hdlc: disabled
DTMF settings: DTMF relay: enabled
encoder mode: muted
SN(cfg)# gateway isoip isoip
SN(gw-isoip)[isoip]# use voip-profile Wire128kbit
SN(gw-isoip)[isoip]#
We have omitted the configuration of the ISDN ports and show the configuration of the codec and
enabling of the gateway.
SN(gw-isoip)[isoip]# codec g723_5k3 20
SN(gw-isoip)[isoip]# no shutdown
Last we have to enable the CS configuration. For more information refer to Chapter
25 , “ CS Interface
Configuration ”.
Software Configuration Guide Release 2.10, Revision 1.00