Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 142 / 357

142 Serial Port Configuration
16.17.2 Displaying Frame Relay Information
The following example shows the commands used to display Frame Relay configuration settings for
a SmartNode 2300 series device. Moreover a typical command output is listed below.
SN> enable
SN# configure
SN(cfg)# show framerelay
Framerelay Configuration:
Port
LMI-Type Keepalive Fragmentation
----------------------------------------------------------
serial 0 0 0
ansi 10 enabled
PVC Configuration:
Port
DLCI State Encaps Binding
----------------------------------------------------
serial 0 0 0
1 open rfc1490 wan@router
16.17.3 Integrated Service Access
The example in Figure a typical integrated service access scenario, where different service
providers are accessed via permanent virtual circuits (PVCs) on Frame Relay over the serial interface
of a SmartNode 2300 series device.
The multi service provider (MSP) offers both Internet access and voice services based on IP. The
virtual private network (VPN) provider offers secure interconnections of local access networks
(LAN) via its public wide are network based on IP. Since both providers are working independently
the SmartNode 2300 series device needs a configuration, which has two dedicated PVCs on Frame
Relay. The first PVC, labeled as PVC 1, connects to the MSP access device. The second PVC, labeled
PVC 2, connects to the VPN provider access device on the leased line network.
A SmartNode 2300 series device is working as a DTE and accesses the leased line network via a
leased line modem connected to the serial interface. On the serial interface on slot 0 and port 0 the
hardware port protocol X.21 is used.
16-2 shows
Software Configuration Guide Release 2.10, Revision 1.00