Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 266 / 357

266 Tone Configuration
Figure 27-1: Assign Tone-Sets to CS Context and CS Interfaces
Note: There is a default tone-set named 'default', which maps the three Swiss standard in-band tones.
Create a tone-set profile only if this default profile corresponds not with your country.
27.1.2 MGCP-Events
MGCP uses events to request tone playback on the gateway. There are several dozens of events. The
MGCP gateway provides a mapping of the MGCP events to configured call-progress-tones. To map
MGCP events to call-progress-tones refer to Chapter XX, “MGCP/SCTP/IUA Configuration”.
27.2 Tone Configuration Task List
To configure call progress tones, perform the tasks described in the following sections.
• Configure Call-Progress-Tone Profiles
• Configure Tone-Set profiles
• Enable Generation of Local In-Band Tones
• Show Call-Progress-Tone and Tone-Set Profiles
27.3 Configure Call-Progress-Tone Profiles
Each call-progress-tone consists of a sequence of different tones and pauses. Arbitrary tone cadences
can be configured. With these parameters all country specific tones can be defined. Tone
configuration knows only one command, that have to be used repeatedly. The sequence in which the
commands are entered (or appear in the config file) defines the sequence in which the corresponding
elements are played.
Software Configuration Guide Release 2.10, Revision 1.00