Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 49 / 357

Accessing the Command Line Interface 49
Note: The “*” character identifies the identity of the user executing the who command. ID represents
the ID of the account. State represents the actual running condition of the user, which can be logout,
login, exec and config.
Used in operator execution mode:
SN> who
You are operator support
6.16 End a Telnet or Console Port Session
To end a Telnet or console port session you use the logout command in the operator or
administration execution mode. To confirm the logout command you have to enter “yes” on the
dialog line as show in the example below.
Procedure
To terminate a session
Mode
Operator execution
Command Purpose
Step 1 node >logout Terminates session after a confirmation by user.
Example: End a Telnet or Console Port Session
The following example shows how to terminate a session from the administrator execution
configuration mode.
SN> logout
Press 'yes' to logout, 'no' to cancel :
After confirming the dialog with “yes” the Telnet session to the SmartNode is terminated and the
Telnet application window on your host closes.
Note: Using the command exit in the operator execution mode also terminates a Telnet or console
port session, but without any confirmation dialog.
Software Configuration Guide Release 2.10, Revision 1.00