Inalp Networks SmartWare Release 2.10, Software Configuration Manual, Page: 80 / 357

80 Basic System Management
Procedure
To determine the running CLI version and define another CLI version
Mode
Configure
Command Purpose
Step 1 node (cfg)#show version cli
Displays the currently running CLI version
Step 2 node (cfg)#cli version
version.revision
Selects the active CLI version in the form
version.revision
Example: Defining the desired CLI Version
The following example shows how to determine the running CLI version and define CLI version 2.10
for your device, if you start from the configuration mode.
SN(cfg)# show version cli
CLI version : 2.00
SN(cfg)#
cli version 2.10
10.10 Restarting The System
In case the SmartNode has to be restarted, the reload command must be used. The reload command
includes a two-step dialog, where the user is allowed to store any unsaved configuration data and
finally confirms the system restart.
Warning
Restarting the system interrupts running data transfers and all voice calls established via the
SmartNode that is to be restarted.
Procedure
To restart the currently running system.
Mode
Administrator execution
Command Purpose
Step 1 node #reload Restarts the system
Example: Restarting The System
The following example shows how to restart the currently running system, if you start from the
administrator execution mode.
SN# reload
System configuration has been changed.
Press 'yes' to store, 'no' to drop changes :
yes
Press 'yes' to restart, 'no' to cancel : yes
The system is going down
Software Configuration Guide Release 2.10, Revision 1.00