Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 91 / 357

IP Interface Configuration 91
Software Configuration Guide Release 2.10, Revision 1.00
Now delete the interfaces named “eth3” with the no interface command:
Command Purpose
Step 1 node (ctx-ip)[router]#interface
name
Creates the new interface name , which represents
an IP interface. This command also places you in
interface configuration mode for the interface just
created.
Step 2 node (if-ip)[ name ]# You are now in the interface configuration mode,
where specific configuration parameters for IP
interface
name can be entered
Example: Create IP Interfaces
The procedure illustrated below assumes that you would like to create an IP interface named lan Use
the following commands in administrator configuration mode.
SN> enable
SN# configure
SN(cfg)# context ip router
SN(ctx-ip)[router]# interface lan
SN(if-ip)[lan]#
12.4 Deleting an IP Interface
Almost every configuration command has a no form. In general, use the no form to disable a feature
or function. Use the command without the no keyword to re-enable a disabled feature or to enable a
feature that is disabled by default.
Delete an existing interface in the IP context is often necessary. The illustrated procedure below
assumes that you would like
Procedure
To delete the IP interface name
Mode
Context IP
Command Purpose
Step 1 node (ctx-ip)[router]#no
interface name
Deletes the existing interfaces name
Example: Delete IP Interfaces
The illustrated procedure below assumes that you would like to delete an IP interface named
external . Use the following commands in IP context configuration mode.
First list the existing interfaces:
SN(ctx-ip)[router]# interface <?>
<interface> New interface
lan Existing interface
wan Existing interface
external Existing interface
internal Existing interface