Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 71 / 357

Configuration File Handling 71
#----------------------------------------------------------------#
cli version 2.00
snmp community public rw
…
…
framerelay
exit
SN#
9.9 Displaying Configuration File Information
Procedure
To display information about configuration files
Mode
Administrator execution
Command Purpose
show nvram: List of all persistent configurations
show running-config Displays the contents of the running configuration file
show startup-config Displays the contents of the startup configuration file
9.10 Modifying the Running Configuration at the CLI
The SmartWare accepts interactive modifications on the currently running configuration via the CLI.
Interactive configuring needs access to the CLI. Use the
enable command to enter administrator
execution mode, and then switch into the configuration mode by typing the command configure .
Once in configuration mode you can enter the configuration commands that are necessary to your
SmartNodes operating. When you configure SmartWare using the CLI, the shell executes the
commands as you enter them.
When you log-in to a SmartNode using the CLI all commands entered directly modify the running
configuration, which is located in the volatile memory region
system: (or RAM) of your SmartNode.
Remember that this memory is - as its name suggests - volatile, therefore if your modifications shall
be permanent you have to copy the configuration to the persistent memory. In most cases you will
store it as the upcoming startup configuration and therefore store it in the persistent memory region
nvram: under the name startup-config . On the next start-up the system will initialize itself using the
modified configuration. As a final step the SmartNode has to be restarted using the reload
command.
Procedure
To modify the running configuration at the CLI and store it as the startup configuration
Mode
Administrator execution
Software Configuration Guide Release 2.10, Revision 1.00