Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 168 / 357

168 Access Control List Configuration
Software Configuration Guide Release 2.10, Revision 1.00
in Specifies that the access control list profile applies to incoming packets on this
interface.
SN(cfg)#
19.8 Bind and Unbind an Access Control List Profile to an
IP Interface
The command use is used to bind an access control list profile to an IP interface.
Procedure
To bind an access control list profile to incoming packets on an IP interface
Mode
Profile access control list
Command Purpose
Step 1 node (if-ip)[ if-name ]#use profile acl name in
Binds access control list profile
name to incoming packets on IP
interface if-name
Where the syntax is:
Keyword Meaning
if-name The name of the IP interface to which an access control list profile gets bound
name The name of an access control list profile that has already been created using the
profile acl command. This argument must be omitted in the no form
in Specifies that the access control list profile applies to incoming packets on this
interface.
out Specifies that the access control list applies to outgoing packets on this interface.
The
no form of the use command is used to unbind an access control list profile from an interface.
When using this form the name of an access control list profile, represented by the name argument
above, is not required.
Procedure
To unbind an access control list profile to incoming packets on an IP interface
Mode
Interface
Command Purpose
Step 1 node (if-ip)[ if-name ]#no use profile acl in
Unbinds access control list profile
for incoming packets on IP
interface
if-name
Where the syntax is:
Keyword Meaning
if-name The name of the IP interface to which an access control list profile gets bound