Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 126 / 357

126 Link Scheduler Configuration
queue has grown over half the “queue-limit”. This improves the performance of TCP flow-control. A
burst-tolerance index between 1 and 10 may optionally be specified (exponential filter weight). The
no form of this command reverts the queue to default “tail-drop” behavior.
Procedure
Defining random early detection
Mode
Source
Command Purpose
node (src)[ name ]#random-detect { burst-
tolerance }
Defines random early detection (RED) for
queues of for the
selected class or policy name.
The range for the optional value burst-tolerance
is from 1 to 10.
15.8.10 Discarding Excess Load
The command police controls traffic arriving in a queue for class name . The value of the first
argument average-kilobits defines the average permitted rate in kBit/s, the value of the second
argument kilobits-ahead defines the tolerated burst size in kBit/s ahead of schedule. Excess packets
are dropped.
Procedure
Defining discard excess load
Mode
Source
Command Purpose
node (src)[ name ]#police average-kilobits burst-
size kilobits-ahead
Defines how traffic arriving in a queue for the
selected class or policy name has to be
controlled. The value average-kilobits for
average rate permitted is in the range from 0 to
10000 kBit/s. The value
kilobits-ahead for burst
size tolerated ahead of schedule is in the range
from 0 to 10000.
15.9 Devoting the Service Policy Profile to an Interface
Any service policy profile needs to be bound to a certain IP interface to get activated. According the
terminology of SmartWare a service policy profile is
used on a certain IP interface, as shown in Figure
15-9 below.
Software Configuration Guide Release 2.10, Revision 1.00