Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 239 / 357

CS Interface Configuration 239
Step 3 node ( if- type )[ if-name ]#fallback
dest-interface name
Specify a fallback interface for incoming calls
Step 4 node ( if- type )[ if-name ]#exit Go back to the CS context configuration mode
Step 5
Repeat steps 1-3 for all the required CS
interfaces
Example: Configure Call Routing
The following example shows how to configure basic interface routing including fallback.
SN> enable
SN# configure
SN(cfg)# context cs
SN(ctx-cs)[switch]# interface pstn PBX_trunk
SN(if-pstn)[PBX_tru~]# routing dest-interface H323_0
SN(if-pstn)[PBX_tru~]# fallback dest-interface Public_access
SN(if-pstn)[PBX_tru~]# exit
SN(ctx-cs)[switch]#
25.5 Configure Digit Collection
The SmartWare CS context supports overlap dialing on all interfaces. Some of the connected devices
(PBX, ISDN network, remote gateways and gatekeepers) may however require bloc sending of the
dialed number. SmartWare offers three options to collect overlap dialed digits and forward them in a
single call setup message. Digit collection is applied to call setups going out from the interface to the
port or gateway as illustrated in Figure 25-2.
Figure 25-2: Digit Collection in a H.323 / ISoIP Interface
Collected overlap dialed digits are sent providing that they comply with one or a combination of
three criteria: elapse a specific timeout, receive a specific character or receive a specified number of
dialed digits.
Procedure
To configure the digit collection
Software Configuration Guide Release 2.10, Revision 1.00