Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 214 / 357

214 PPP Configuration
Step 3 node (cfg) #show pppoe [ name ]
Displays status, configuration information, and
statistics of PPPoE in general and of the PPPoE
Session(s). Check whether state of the respective
session is ‘Opened’.
level specifies to level of details displayed (1..4,
default is 1).
Step 4 node (cfg) #show port interface
name
Displays status and configuration information of
the IP interface at which a PPP connection
terminates. Check whether state of the interface is
‘OPENED’.
Under ‘Local IP Address’, you find the IP address
assigned to the IP interface. If it does not
correspond to the IP address assigned by the PPP
remote peer, check whether the ‘ipaddress’ of the
IP interface is set to ‘unnumbered’.
Step 5 node (cfg) #show port ethernet
slot port
or
node (cfg) #show port serial slot
port
Displays status and configuration information of
the Ethernet / serial port over which a PPP
connection / PPPoE Sessions runs. Check
whether state of the port is ‘OPENED’ and
whether the encapsulation is set to ‘pppoe’ or
‘multi’ (only for Ethernet ports).
Step 6 node (cfg) # [no] debug ppp
[ all | ... ]
Enables all or a particular PPP debug monitor.
Step 7 node (cfg) # [no] debug pppoe
[ all | ... ]
Enables all or a particular PPPoE debug monitor.
Example: Display PPP Link Information
SN(cfg)# show ppp links 4
PPP Link Information:
=====================
Link:
ID: 0
Name: ethernet 0 0 0/pppoe/ppp_green
Protocols: LCP, PAP
LCP:
ID: 0
Name: ethernet 0 0 0/pppoe/ppp_green
State: Opened
Conf-Req send rate: 3000ms
Max. Conf-Req: 10
Term-Req send rate: 3000ms
Max. Term-Req: 2
Echo-Req send rate: 10000ms
Max. Echo-Req: 3
Local ID: 100000020390
Remote ID:
Local configured options:
Magic Number = 0x00000000
MRU = 1492 [68,1492]
Software Configuration Guide Release 2.10, Revision 1.00
ACCM = 0xffffffff
Local acknowledged options:
Remote configured options: