Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 53 / 357

Establishing Basic IP Connectivity 53
7.6 Display IP Interface Information
Information for all the configured IP interfaces can be displayed by the show command. The
command lists relevant information for every IP interface. The IP interfaces are identified by the
name.
Procedure
To displays IP interface information
Mode
Configure
Command Purpose
Step 1 node (cfg)#show ip interface Displays IP interface information
Example: List existing IP Interfaces
Displaying IP interface information using the show ip interface command in configuration mode. In
the following example only the information available for IP interface lan is displayed. Depending on
the number of defined IP interfaces the output of the show ip interface command can be longer.
SN(ctx-ip)[router]# show ip interface
…
------------------------------------------------------------
Context:
router
Name: lan
IP Address: 192.168.1.3 255.255.255.0
P2P: point-to-point
MTU: 1500
ICMP router-discovery: enabled
ICMP redirect: send only
State: OPENED
Binding: ethernet 0 0 0/ethernet/ip
…
An easy way to list existing interfaces is by using the
interface command followed by a “ ? ” in the IP
context configuration mode, which creates a list of all the defined IP interfaces.
SN(cfg)# context ip router
SN(ctx-ip)[router]# interface <?>
<interface> New interface
external Existing interface
internal Existing interface
lan Existing interface
wan Existing interface
7.7 Delete IP Interfaces
Deleting an existing interface in the IP context is often necessary. The procedure illustrated below
assumes that you would like to delete the IP interface
name . Use the no argument to the interface
command as in the following demonstration in IP context configuration mode.
Procedu r e
To delete an existing IP interface
Mode
Context IP
Software Configuration Guide Release 2.10, Revision 1.00