Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 242 / 357

242 CS Interface Configuration
Mode
Interface below Context CS
Command Purpose
Step 1 node ( if-type )[ if-name ]#portaddress
address
Specify the port address for a H.323 or ISoIP
interface.
Example: Specifying a Port Address
The following example shows how to set the port address to value 5 for a H.323 interface and enable
Q.931 tunneling to use this feature in an H.323 network.
SN> enable
SN# configure
SN(cfg)# context cs
SN(ctx-cs)[switch]# interface h323 EnterpriseGateway
SN(if-h323)[Enterpr~]# portaddress 5
SN(if-h323)[Enterpr~]# exit
SN(ctx-cs)[switch]# exit
SN(cfg)# gateway h323 h323
SN(gw-h323)[h323]# q931-tunneling
SN(gw-h323)[h323]#
25.8 Bind PSTN Interfaces to PSTN Ports and Create Line
Hunt Groups
In order to become functional the PSTN interface must be bound to the physical PSTN port from
which it receives incoming calls and to which it forwards outgoing calls. Generally a PSTN interface
binds only one PSTN port. If a PSTN interface binds more than one PSTN port a line hunt group is
created. Hunt groups allows you to apply the PSTN interface configuration to multiple physical
ports. Within the hunt groups free channels for outgoing calls are hunted on all available ports. Its
are hunted in the sequence of their binding in the interface configuration.
Procedure
To bind the PSTN interface to a PSTN port
Mode
Interface below Context CS
Command Purpose
Step 1 node ( if-type )[ if-name ]#bind port
slot port
Bind interface to a port
Example: Bind PSTN Interface to PSTN Ports
The following example shows how to create a line hunt group by binding multiple PSTN ports to the
PSTN interface.
SN> enable
SN# configure
Software Configuration Guide Release 2.10, Revision 1.00
SN(cfg)# context cs
SN(ctx-cs)[switch]# interface pstn PublicPSTN
SN(if-pstn)[PublicP~]# bind port 2 0