Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 102 / 357

102 NAPT Configuration
Step 2 node (ctx-ip)[router]#interface
name
The NAPT profile shall be used on the interface
name
Step 3 node (if-ip)[ name ]#use profile
napt profile
Defines that the NAPT profile profile shall be used
on the interface name
Example: Configuring NAPT Interface
The following example shows how to define that the NAPT profile access shall be used on the
interface lan . Use the commands in configuration mode.
SN(cfg)# context ip router
SN(ctx-ip)[router]# interface lan
SN(if-ip)[lan]# use profile napt access
13.10 Display NAPT Configuration Information
To display all settings for an existing NAPT profile the command show profile napt name has to be
used.
Procedure
Show a detailed list of settings for NAPT profile
Mode
Configure
Command Purpose
Step 1 node (cfg)#show profile napt
name
Shows settings for the existing NAPT profile
name
Example: Display NAPT Configuration Information
The listing below shows the step-by-step assembled NAPT profile access . Use the following
commands in configuration mode.
SN(cfg)# show profile napt access
NAPT profile access:
--------------------
Bound to interface: router/lan
ICMP default server: 192.168.1.20
Protocol Port Destination Host
--------------- ----- ----------------
tcp
80 192.168.1.1
Software Configuration Guide Release 2.10, Revision 1.00