240
CS Interface Configuration
Software Configuration Guide Release 2.10, Revision 1.00
Mode
Interface below Context CS
Command
Purpose
Step 1
node
(
if- type
)[
if-name
]#digit-
collection timeout
seconds
Specify the timeout to wait for the first dialed or
between two dialed digits before all previous
digits are sent.
Step 2
node
(
if- type
) [
if-name
]#digit-
collection terminating-char
character
Specify a character that indicates the end of the
dialed digits # or *
Step 3
node
(
if- type
) [
if-name
]#digit-
collection nr-length
length
Specify a number of digits to collect
Example: Configure Digit Collection
In the following example the SmartNode sends the bloc of numbers either when the asterisk
character '*' is received or after 4 seconds have elapsed since the last dialed digit.
SN(if-h323)[h323_0]#
digit-collection timeout 4
SN(if-h323)[h323_0]#
digit-collection terminating-char *
25.6 Configure Direct Call Signaling on VoIP Interfaces
Call signaling is a basic requirement needed to set up and close down a call between two endpoints.
A call can be established between two VoIP interfaces, that is either between two ISoIP or between
two H.323 interfaces. So that a call can be set up the VoIP interface needs the IP address of its remote
device. In direct call signaling this is configured for each VoIP interface directly. In an H.323 network
it is possible to obtain the remote IP addresses automatically by a gatekeeper. This is called
'gatekeeper routed call signaling'. To configure an H.323 interface for 'gatekeeper routed call
signaling' refer to Chapter
22
, “
DHCP Configuration
”.
Note:
If you specify direct call signaling for an H.323 connection make sure that the registration
authentication service (RAS) is disabled. For more information on RAS refer to Chapter
22
, “
DHCP
Configuration
”. For an example refer to the examples at the end of this chapter.
Note:
Compared to H.323, the ISoIP signaling is simpler, faster and more efficient.
Procedure
To configure Direct Call Signaling on a VoIP interface
Mode
Context CS
Command
Purpose
Step 1
node
(ctx-cs)[switch]#interface h323
if-name
or
node
(ctx-cs)[switch]#interface
isoip
if-name
Enter interface configuration mode and
configure a H.323 or ISoIP interface for 'direct
call signaling'.
Step 2
node
(if
- type
) [
if-name
]#remoteip
ipaddress
Set the remote IP address for this VoIP interface
Summary of Contents for SmartWare Release 2.10
Page 2: ...2 Legal Notice Software Configuration Guide Release 2 10 Revision 1 00...
Page 15: ...Terms and Definitions 15 Software Configuration Guide Release 2 10 Revision 1 00...
Page 218: ...218 PPP Configuration no shutdown Software Configuration Guide Release 2 10 Revision 1 00...
Page 272: ...272 Tone Configuration Software Configuration Guide Release 2 10 Revision 1 00...