Inalp Networks SmartWare Release 2.10, Software Configuration Manual

Page: 192 / 357

192 SNTP Client Configuration
21.12 Showing SNTP Client Related Information
During set-up and operation of the SNTP client, displaying the information and status of the SNTP
client is very useful.
Procedure
To display information and status of the SNTP client
Mode
Configure
Command Purpose
Step 1
node (cfg)#show sntp-client Displays information and status of the
SNTP client
Example: Show ing SNTP Client Related Information
SN(cfg)# show sntp-client
-------------------------------------------
SNTP client
enabled
Operating mode unicast
Local port 123
Primary server 172.16.1.10:123 v4
Secondary server 128.138.140.44:123 v4
Anycast address 224.0.1.1:123
Poll interval 30sec
Local clock offset disabled
GMT offset
+2:00:00
-------------------------------------------
21.13 Debugging SNTP Client Operation
During setup and operation debugging the behavior SNTP client is very useful.
Note: The debug sntp client is only available in superuser mode.
Procedure
To enable or disable debugging
Mode
Configure
Command Purpose
Step 1 node (cfg)#debug sntp client
Enables and disables SNTP debug
monitor. Using the no command
syntax disables this feature.
Example: Enable the SNTP Debug Monitor
The following example shows how to enable the SNTP debug monitor and some typical debug
information.
SN(cfg)# debug sntp client
SN(cfg)#14:44:21 SNTP > SNTP message sent with Timestamp: 2001-10-
Software Configuration Guide Release 2.10, Revision 1.00
26T14:44:21
14:44:21
SNTP > SNTP message received:
------------------------------------------------