Fukuda Denshi VaSera VS-1500, Service Manual

Page: 152 / 216

Chapter 8 Disassembly and Assembly
Confidential Copying Prohibited
8-35
8.7 Installation of the Hose Hanger Kit OA-130
This product kit can be used as a hose hanger for the Vasera Series by attaching to the
OA-300A Cable Hanger (separately sold). Note that the kit cannot be used with any other cable
hanger.
CAUTION
z Do not install this hose hanger on a trolley other than the one
specified for the Vasera Series. The trolley could tip over causing
unforeseen injuries.
z Do not place the cuffs on or suspend them from the hose hanger.
The trolley could tip over causing unforeseen injuries.
8.7.1 Parts List
Name Q’ty Function
Sensor holder (1) 1 For holding the PCG microphone and pulse wave sensors.
Sensor holder (2) 1 Same as above.
Hose clips 6 For holding lead cables and air hoses in place.
Front end hose clip 1 For holding the air hose on the OA-300A.
Sensor cable clip 4 For h
olding the PCG microphone and pulse wave sensor cables.
Spiral tube (large) 6 For bundling the sensor cables (max. 3).
Spiral tube (small) 6 Smaller size of above.
8.7.2 Installation Procedure
1. First, set the lead cable relay part by following the procedure explained on OA-300A Cable
Hanger Operation Manual.
2. Next, insert the hose clips at appropriate locations on the arm to support the lead cables.
placing the lead cable first will facilitate later attachment. To remove them, start from the side
without the lead cable. [Refer to Figure 1.]
3. Insert the sensor holder (1) inside the limb electrode clamp and position it where desired.
Then clip in the sensor holder (2) until it clicks into place. [Refer to Figure 2.]
Hose Clip
[Figure 1]
Sensor Holder (1)
Sensor Holder (2)
[Figure 2 Sensor Holder Attachment]
Limb Electrode Clamp
Convex Part