-
In the pre-upgrade environment, the patch for Problem Report Number PH09090 has already been applied to the
Management Server.
-
The storage device that is in use is the ETERNUS DX60 S3/DX100 S3/DX200 S3 or the ETERNUS DX200F, whose firmware
version is V10L60 or later.
If the above conditions are not satisfied and you use the new supported function from this version level, perform the following
operations with Web Console to reload the server information.
a.
On the global navigation tab, click Storage.
The registered ETERNUS Disk storage systems are displayed in the Main pane.
b.
On the Main pane, check the target ETERNUS Disk storage system checkbox.
c.
On the Action pane, click Reload Conf. under Storage.
See
Refer to "Reload ETERNUS Disk Storage System Configuration Information" in the
ETERNUS SF Web Console Guide
for this version
for information on reloading the configuration information.
Information
After upgrading to this version, when changing the SNMP communication protocol used for fault management from SNMPv1 to
SNMPv3, refer to the following section in the chapter "Maintenance" in the
ETERNUS SF Express Operation Guide
for this version and
configure your operational environment.
-
"Changing Express's Manager Environment (Windows)" > "Changing SNMP Communication Protocol"
Note
Information related to the captured capacity and the captured logs before the upgrade is not displayed on the Dashboard. Refer to the
following screens:
-
Capacity information
-
Capacity Graph of Thin Provisioning Pool
-
Capacity Graph of Tier Pool
-
Logs information
-
Operation History
-
Events
-
Threshold Monitoring Alarms
-
Quota Management (NAS Management)
4.2 Upgrading Express (for Linux)
4.2.1 Preparing for Upgrade
- 24 -
