Docomo N-09A, Instruction Manual

Page: 48 / 572

46
Before Using the
Handset
Charging with the desktop holder
1 Plug the connector of the AC
adapter (optional) horizontally to
the terminal on the back of the
desktop holder (optional)
2
Plug the AC adapter into the outlet
3 As shown in the illustration, hold
the desktop holder down and
insert the FOMA terminal in
direction
① and place it in
direction ②
4 After charging is complete, hold
down the desktop holder, then lay
and lift the FOMA terminal up in
the direction of the arrow
Plug the connector with
arrows side facing upward
100V AC power outlet
Plug
FOMA AC Adapter 01/02
Desktop Holder
N15
Charge
lamp
Connector
N
z
The charge lamp lights up in red during charging.
The charge lamp turns off when charging ends
(fully charged).
z
The battery pack cannot be charged separately.
Always charge with the battery pack attached to
the FOMA terminal.
z
If the battery runs out, the charging lamp may not
light up immediately, but the charging itself has
started.
<AC adapter/DC adapter>
z
If the power is on, “ ” flashes during charging,
and the battery level indicator appears. After
charging ends, “
” lights up.
z
When the charge lamp of the FOMA terminal
(Phone) turns off, “
” disappears and the
message “Charge unusual Stop charge” appears,
disconnect the FOMA terminal from the AC
adapter or DC adapter and remove the battery
pack. Then set them again for recharging. If the
same error occurs again, there may be a problem
or fault on the AC adapter or DC adapter. Contact
a docomo Shop or Service Counter.
z
The DC Adapter uses a 2A fuse. If the fuse (2A)
blows, always use the dedicated fuse. Fuses (2A)
are consumable items. Purchase a replacement
fuse at your local car accessory shop, etc.
<Desktop holder>
z
Attach the FOMA terminal to the desktop holder
securely. Also, take care not to pinch the strap.