43
Confirming
before
Use
Press and hold
for at least one second.
After the Wake-up display (see page 126) is displayed, the Stand-by display appears.
●
If you have stored many Phonebook entries or mail messages, it may take a while for the display to
appear.
●
If the clock is set, the current date and time are shown. When Set Time is set to “Automatic”, the time is
automatically compensated.
●
When “
” is displayed, the FOMA phone is out of the service area or in the place where the radio
waves do not reach. Move to a location where “
” disappears.
●
When “PIN1 code entry set” of “PIN setting” (see page 148) is set to “ON”, enter the four- to eight-digit PIN1 code after you
turn on the power. When the correct PIN1 code is entered, the Stand-by display appears. See page 146 for PIN1 code.
●
When “Auto reset setting” of “Notice call cost” is set to “ON”, enter the four- to eight-digit PIN2 code after you turn on the
power. When the correct PIN2 code is entered, the Stand-by display appears. If you press
or
without entering the
correct PIN2 code, “Auto reset setting” is set to “OFF” and the Stand-by display appears.
See page 146 for PIN2 code.
●
If the UIM is not attached or there is something wrong with it,
a warning message will come up.
1
<Stand-by display>
When the UIM is
malfunctioning
When the UIM is not
attached or damaged
■
To turn the power off
Press and hold
for at least two seconds.
The exit display appears and the power goes off.
●
You cannot turn on the power immediately after turning off the power. Wait a few seconds.
●
If “Starting system Wait a minute” is displayed when you turn on the power, wait for a while and then proceed.
●
The radio waves become unstable when you move around during a call. Because of the nature of the digital technology, your call
might be cut off suddenly. Try to keep
displayed when using the FOMA phone.
●
The default Stand-by display differs depending on the color of the handset. In this manual, the descriptions for the Stand-by display
are given using the “Silver x GEKKA” color handset. See page 125 for the default Stand-by displays of the handsets in other colors.
Information
■
When you have not operated FOMA phone for a certain period
If you have not operated the FOMA phone for a certain period while it has been turned on, the indication on the display and Private
window goes off and the Command Navigation key flickers at about five-second interval when the FOMA phone is opened. The
display comes on again when you perform any operation.
●
You can set the display to remain on, for even when the FOMA phone has not been operated for a certain period, by setting
“Power saver mode” of “Display setting” to “OFF”. (See page 128)
<Power ON/OFF>
Turning Power On/Off
ディスプレイ
(Display)
バイリンガル
(Select language)
Japanese (
日本語
)······Switches to Japanese.
English (
英語
)··············Switches to English.
1
<Select Language>
Setting at purchase
Japanese
Switching to English