Zeiss LSM 880, Руководство по эксплуатации

Страница: 295 / 690

CHAPTER 1 - SYSTEM OPERATION
LSM 880 Left Tool Area and Hardware Control Tools ZEISS
10/2014 V_01 000000-2071-464 289
(5) State display box
The State display box (Fig. 385) above the Fit action buttons informs you about the fitting conditions.
Whenever some inconsistencies are present, e.g having to parameters free that depend on each other,
like the geometric factor and the number of molecules, the system gives a warning about the mistake.
(6) Fit action buttons
The Fit action buttons enables you to perform a fit and adapt the fit process (Fig. 386).
Fit:
will perform a fit for all highlighted measurements (rows) according to the loaded model.
When the fit is completed, the free parameters will be replaced with the new fitting results and the fit
graph and result table will also be updated.
Fit all: will perform a fit for all measurements (rows) that have the same channel as the one displayed in
the Channel display field. All other channels will not be fitted. If you change to a row with a different
channel, the last assigned model will load for that row.
Undo: cancels a previous command. Repeatedly pressing will cancel commands in the reverse of their
execution.
Redo:
re-executes a previously undone command and hence will become only active, if an action was
performed. Repeatedly pressing will re-execute previous undone commands in the order of their previous
execution.
To Method:
writes the current displayed
Model
settings into the method. Hence parameter values and
their type of the selected fitting model are assigned to the model used in the current method. If you want
to keep the changes permanently, the method has to be stored.
Note that all actions are also available in the context menu of the
Fit table
.
Fig. 385 State display box
Fig. 386 Fit action buttons with empty State display box