Zeiss LSM 880, Руководство по эксплуатации

Страница: 135 / 690

CHAPTER 1 - SYSTEM OPERATION
LSM 880 Left Tool Area and Hardware Control Tools ZEISS
10/2014 V_01 000000-2071-464 129
Find offset searches for a reflective surface (the focus reference plane) starting at the Z-level of the
imaging plane. Next, it copies the increment between the Z-levels of the imaging plane and the focus
reference into the
Offset
spin box. See description of
Positions
tool (section
Multidimensional
Acquisition – Positions ) for details on how to specify Offset values in multi-position experiments.
Autofocus Map mode
Autofocus Map aims to minimize the time spent on maintaining focus stability in experiments that
involve multiple cycles of data recording from arrayed samples. This autofocus mode is therefore helpful
when working with e.g. microtiter plates that are slightly tilted or feature wells with uneven bottoms.
Autofocus Map is only available in the
Sample Carrier method of the Positions tool and cannot be
combined with
Tile Scan
.
Before starting an imaging experiment using Autofocus Map , a Focus Map has to be recorded for all
positions selected in the method
Sample Carrier
. If no
Focus Map
is present, ZEN displays the
notification .
After pressing , ZEN uses laser reflection (see autofocus mode Refelction for details) to
map the reference planes in all these positions. This information is stored (but not displayed) as a
Focus
Map . After the successful generation of a Focus Map, ZEN displays the notification .
The fundamental requirements as well as the strategy for using Offset are identical in Autofocus Map
and
Reflection
(see above).
The same Offset value is applied to all positions of the sample carrier. As the Focus Map is only created
once and its information subsequently used in all acquisition cycles,
Autofocus Map
provides a speed
improvement when working with arrayed samples. Autofocus Map does not correct for Z-drift over time.
If such compensation is needed, the autofocus mode
Reflection should be selected for arrayed samples.
Definite Focus mode
Selecting this mode activates the Definite Focus unit. Activity intervals (see below) are set like with all
other autofocus modes. See operating manual of Definite Focus for reference.
Specifying Activity intervals for focus actions
Activity intervals for focusing can be specified for
the
Fluorescence , Reflection , and Definite
Focus modes.
It is advisable to minimize the number of focusing
activities in order to improve the speed of the
overall acquisition and to protect delicate samples
from laser damage.
However, optimal conditions need to be
determined experimentally.
As soon as one of the acquisition tools
Time Series , Tile Scan , or Positions is activated, focus intervals
can be linked to these tools in Focus Devices and Strategy (Fig. 171).
Fig. 171 Specifying activity intervals for
focus activities